Yamaha RXV2092 - Manual (Page 63)

59
English
In using the digital sound field processor including the Dolby Pro
Logic Decoder or the Dolby Digital (AC-3) Decoder, you can adjust
delay time between the main sound and effect sound, and each
speaker output level as you prefer.
NOTE: These adjustments can be made only when the effect
sound is on. If
and/or (or ) is not
illuminated on the display panel, press the EFFECT switch on the
front panel or the EFFECT ON/OFF key on the remote control unit
so that at least one of those indicators lights up on the display
panel.
1. If you will use the remote control unit, set the TIME/LEVEL·SET
MENU switch to the TIME/LEVEL position on the remote control unit.
NOTE: Be sure to use the remote control unit with the lid open.
2. Press once or more until the name of item on which you will make
an adjustment appears on the display panel.
Whenever pressed, the selection changes as follows.
* Depending on a mode of this unit, the number of selections is
reduced.
* Pressing the key on the remote control unit changes the
selection in the reverse order.
3. Adjust its level.
4. Repeat step 2 and 3 to make adjustments on other items.
PRO LOGIC DIGITAL DSP
ADJUSTING DELAY TIME AND EACH SPEAKER OUTPUT LEVEL
Remote control
TIME/LEVEL
SET MENU
or
Front panel Remote control
D E L A Y T I M E
F R O N T L E V E L
C E N T E R L E V E L
R S U R . L E V E L
L S U R . L E V E L
S W F R L E V E L
(Delay time)
(Center speaker output
level)
(Right rear speaker output
level)
(Left rear speaker output
level)
(Front effect speaker
output level)
(Subwoofer output level)
Remote control Front panel
or
DELAY/C/R
/F/SWFR