Yamaha RX-SL80 - Manual (Page 52)

48
EDITING SOUND FIELD PARAMETERS
3
Press / repeatedly to access the sound
field program parameters.
4
Press / repeatedly to adjust the sound
field parameter.
5
To change parameter values for a different
sound field, repeat steps 2 through 4.
You cannot change parameter values when Memory Guard is set
to “ON”. If you want to change the parameter values, set Memory
Guard to “OFF” (see page 43).
■ DSP LEVEL
Function: This parameter adjusts the level of all the
DSP effect sounds within a narrow
range.
Description: Depending on the acoustics of you
listening room, you may want to increase
or decrease the DSP effect level relative
to the level of the direct sound.
Control range: –6 to +3 dB
■ DELAY
Function: This parameter changes the apparent
distance from the source sound by
adjusting the delay between the direct
sound and the first reflection heard by
the listener.
Description: The smaller the value, the closer the
sound source seems to the listener. The
larger the value, the farther it seems. For
a small room, set to a small value. For a
large room, set to a large value.
Control range: 1 to 99 ms
For 5ch Stereo
Function: These parameter adjusts the volume level
for each channel in 5-channel stereo
mode.
Control Range: 0 to 100%
■ CT LEVEL (Center level)
■ SL LEVEL (Surround left level)
■ SR LEVEL (Surround right level)
For PRO LOGIC II Music
■ PANORAMA
Function: Extends the front stereo image to include
the surround speakers for wraparound
effect.
Choices: OFF/ON, initial setting is OFF.
■ DIMENSION
Function: Gradually adjusts the sound field either
towards the front or towards the rear.
Control range: –3 (towards the rear) to +3 (towards the
front), initial setting is STD (standard).
■ CT WIDTH (Center width)
Function: Adjusts the center image from all three
front speakers to varying degrees. A
larger value adjusts the center image
towards the front left and right speakers.
Control range: 0 (center channel sound is output only
from center speaker) to 7 (center channel
sound is output only from front left and
right speakers), initial setting is 3.
Note
ENTER
ENTER