Zanussi ZGF 647 - Manual (Page 5)

5
2.Cleaning and Maintenance
• Disconnect the appliance from the electrical
supply, before carrying out any cleaning or
manteinance work.
GENERAL CLEANING
Wash the enamelled components with warm soapy
water. Never use abrasive cleaners
Frequently wash the "caps" and the "crowns" with hot
soapy water, carefully taking away any built-up of food.
If the marks are particularly difficult to remove, use
common non-abrasive cleaners or specific products.
Never use steel wool pads or acids.
AUTOMATIC IGNITION
The automatic ignition of the gas burners is obtained
through a ceramic "candle" and a metal electrode (fig. 1
lett. C). Keep these components well clean, to avoid
difficult lighting, and check that the burner crown holes
(lett. B) are not obstructed.
PAN SUPPORTS
The hobs are provided with enamelled pan supports (thin
and light - fig.2).To keep the pan supports in the right
position, they are hooked to a couple of special hinges
in the back of the hob.
Thanks to these hooks, you can lift the pan supports for
easier cleaning (fig. 2). To take the pan supports
completely off the hob, proceed as shown in fig. 3.
The pan supports are dishwasher proof.
THE HOB LID
In order to make the appliance match with the kitchen
design, a lid can be fitted on the hob.
l The lid (not provided) is meant to avoid dust to
settle on the hob, when it is closed, and to collect
splashes of oil or fat, when it is open. Do not use
it for any other purpose.
l Always wipe off any splash of liquid before
opening the lid.
l Always clean the lid from cooking residues before
opening it or taking it off.
l WARNING! The crystal lid can splinter when
overheated. Always ensure all the burners are
off before closing it.
FO 2238
FO 2030
Fig. 3
Fig. 2