Yamaha HTR-6140 - Manual (Page 59)

55
En
SIRIUS Satellite Radio™ tuning
English
BA
S
IC
OPERA
T
ION
3
Press 8n repeatedly to select “OPTION
MENU” and then press 8
ENTER.
4
Press 8k / n repeatedly to select “G)SIRIUS
SET” and then press 8
ENTER.
The following menu screen appears.
5
Press 8
ENTER.
“NEW PIN:0000” appears.
If a SiriusConnect tuner is not connected to this unit, “Not
Available” appears.
y
If the Parental Lock code number is already set, “PIN:___”
appears instead of “NEW PIN:0000”. Refer to step 8 and
then proceed the operations.
6
Enter the desired 4-digit code number by
using the numeric buttons (G).
y
Press 9RETURN to return the previous menu level
without setting the code number.
7
Press 8
ENTER to confirm the code number.
“OK” appears and then “PIN:___” appears.
8
Enter the 4-digit code number you set at step
6 above to unlock the protection.
When the code number is correct, “OK” and then the
SIRIUS Satellite Radio channel list appears.
9
Press 8l / h repeatedly to select the
desired channel category and then press
8k / n repeatedly to select the channel you
want to lock.
In the SIRIUS Satellite Radio channel list screen, this unit
outputs the sound of the selected channel even if the channel
is locked. Only the first eight characters of each channel
name are displayed in the list.
10
Press 8
ENTER to lock the selected
channel.
Check mark appears before the selected channel.
y
When you select the locked channel and press 8ENTER,
this unit unlocks the selected channel.
11
Repeat steps 9 and 10 to lock the channels
you want.
12
Press 9
RETURN repeatedly to exit from the
“PARENTAL LOCK” screen.
13
Press M
MENU to exit from the setup menu.
This unit is tuned into the last channel you select in
the “PARENTAL LOCK” screen. If the channel is
locked, this unit is tuned into “184 SIRIUS Weather
& Emergency” or “000 Sirius IDxxxxxxxxxxxx”
(“xxxxxxxxxxxx” indicates the Sirius ID of your
SiriusConnect tuner).
y
If you forget or want to change the Parental lock code number,
use “SSR PIN” in “ADVANCED SETUP” to reset the Parental
Lock code number.
■ Tuning into the locked channels
You can tune into the locked channels by the Direct
number access mode or preset channel mode. When you
tune into the locked channel, following message appears
in the front panel display. Enter the code number you set
for the Parental Lock feature by using the numeric buttons
(G) or press TENT to cancel the tuning.
If the entered code number is incorrect, “Wrong” appears in the
front panel display and this unit is tuned into the previously
selected channel.
Note
3 OPTION MENU
G)SIRIUS SET
. PARENTAL LOCK
[ ]/[ ]:Up/Down
[
p]/[[]:Select
[ p
PARENTAL LOCK
NEW PIN:0000
[0] [9]:NUMBER
[ENT]:ENTER
-
Note
Note
PIN:____
01EN_HTR-6140_U.book Page 55 Friday, February 1, 2008 2:26 PM