Yamaha HTR-6140 - Manual (Page 52)

48
En
XM Satellite Radio tuning
y
Before performing operations, press 3XM to select “XM” as the
input source.
■ All Channel Search mode
1
Press B
SEARCH MODE (or MSRCH
MODE) repeatedly to select “ALL CH
SEARCH”.
2
Press E
PRESET/TUNING/CH l / h (or
8 PRESET/CH k / n) repeatedly to search
for a channel within all channels.
y
• You can search for a channel quickly by pressing and holding
EPRESET/TUNING/CH l / h (or 8PRESET/CH k / n).
• To display the XM Radio ID number displayed in the front
panel display, select channel “0”.
■ Category Search mode
1
Press B
SEARCH MODE (or MSRCH
MODE) repeatedly to select “CAT SEARCH”.
2
Press D
CATEGORY (or 8A-E/CAT. l / h)
repeatedly to change the channel category.
3
Press E
PRESET/TUNING/CH l / h (or
8 PRESET/CH k / n) repeatedly to search
for a channel within the selected channel
category.
y
You can search for a channel quickly by pressing and holding
EPRESET/TUNING/CH
l / h (or 8PRESET/CH k / n).
■ Preset Search mode
Prior to selecting a preset channel in the Preset Search
mode, you must preset XM Satellite Radio channels. For
details, see “Setting XM Satellite Radio preset channels”
on page 49.
y
All preset channels (A1 to E8) recalls “001 Preview” by the initial
factory setting.
1
Press B
SEARCH MODE (or MSRCH
MODE) repeatedly to select “PRESET
SEARCH”.
2
Press D
CATEGORY (or 8A-E/CAT. l / h)
repeatedly to change the preset channel
group (A to E).
3
Press E
PRESET/TUNING/CH l / h (or
8 PRESET/CH k / n) repeatedly to change
the preset channel number (1 to 8).
y
You can also select the preset channel number directly by
pressing the numeric buttons (1 to 8) on the remote control.
■ Direct Number Access mode
1
Press M
SRCH MODE repeatedly to select
“ALL CH SEARCH” or “CAT SEARCH”.
2
Press the numeric buttons (G) to enter the
desired three-digit channel number.
For example, to enter the number 123, press the
numeric buttons as shown below.
The display changes as follows.
y
• To enter a one-digit or two-digit channel number, press the
numeric buttons (G) and then press TENT to confirm the
input number. Instead of pressing TENT to tune into the
channel immediately, you can wait a few seconds until this unit
confirms the entered channel number.
• Pressing a button other than the numeric buttons (G) or TENT
cancels the Direct Number Access mode procedure.
1 2 3
--1
-12
123
01EN_HTR-6140_U.book Page 48 Friday, February 1, 2008 2:26 PM