ZyXEL Communications IES-5005 - Manual (Page 78)

IES-5000/5005/6000 Support Notes
77
ports 1 and 2. The following shows the CLI commands.
CI command:
TGE1> sys sw rstp enable
TGE1> sys sw rstp port enable 1
TGE1> sys sw rstp port enable 2
2. Setup IES-2000
2.1 Activating Spanning Tree protocol
This section shows how to enable STP on the IES-2000 using the web configurator.
Access the web configurator and click Switch Setup in the navigation panel to display the
configuration screen as shown. Then select the Rapid Spanning Tree Protocol option to
enable it.
2.2 Activating Spanning Tree protocol on Ethernet ports
ou have activated STP on the system, you must activate STP After y on the Ethernet ports.
, click Port Setup in the navigation panel to display the configuration
msc to display the configuration screen for the Ethernet ports on the
In the web configurator
s shown. Click screen a
MSC line card.
All contents copyright (c) 2008 ZyXEL Communications Corporation.