Zanussi ZOD580 - Manual (Page 18)

3. Hold the door glass panels on their top edge one by
one and pull them upwards out of the guide
4. Clean the door glass panels.
To install panels follow the procedure in reverse. In-
sert the smaller panel first, then the larger.
Oven lamp
Warning! There is a danger of electrical shock!
Before you change the oven lamp:
• Switch off the oven.
• Remove the fuses in the fuse box or switch off the cir-
cuit breaker.
Put a cloth on the bottom of the oven for protection
of the oven light and glass cover.
Replacing the oven lamp
1. You can find the lamp glass cover at the back of the
cavity.
Turn the lamp glass cover counterclockwise to re-
move it.
2. Clean the glass cover.
3. Replace the oven lamp with applicable 300°C heat-
resistant oven lamp.
Important! Use the same oven lamp type.
4. Install the glass cover.
What to do if…
Warning! Refer to "Safety information" chapter.
Problem Possible cause Remedy
The oven does not heat up The oven is not switched on Switch on the oven
The oven does not heat up The clock is not set Set the clock
The oven does not heat up The necessary settings are not set Control the settings
The oven does not heat up The fuse in the fuse box is released Control the fuse. If the fuse is re-
leased more than one time, refer to a
qualified electrician.
The oven lamp does not operate The oven lamp is defective Replace the oven lamp
Steam and condensation settle on the
food and in the oven cavity
You left the dish in the oven for too
long
Do not leave the dishes in the oven
for longer than 15-20 minutes after
the cooking process ends
The display shows “12.00” A power cut Reset the clock
If you cannot find a solution to the problem yourself, con-
tact your dealer or the service centre.
The necessary data for the service centre is on the rating
plate. The rating plate is on the front frame of the appli-
ance cavity.
We recommend that you write the data here:
Model (MOD.)
.........................................
18