Yamaha YPT-230 - Manual (Page 23)

Playing Songs
PSR-E233/YPT-230 Owner’s Manual 23
Press the [DEMO] button.
Songs 001, 002, 003 play in sequence, and playback will continue repeatedly starting again from the first Song 001.
You can stop playback at any time by pressing the [DEMO] or [START/STOP] button.
With the default setting only a few of the internal songs are played back and repeated when the [DEMO/BGM]
button is pressed. This setting can be changed so that all internal songs are played.
Four playback group settings are provided. Simply select the one that suits your needs.
1
Press and hold the [DEMO/BGM] button for longer than a sec-
ond.
“DemoGrp” will appear in the display for a few seconds, then the currently
selected repeat playback target will be displayed.
2
Use the [+] or [-] button to select a repeat playback group from the
table below.
3
Press the [DEMO/BGM] button.
The songs in the group selected play in sequence.
You can stop playback at any time by pressing the [DEMO] or [START/STOP]
button.
Changing the Melody Voice
You can change a Song’s melody Voice to any other desired Voice.
Select the desired Voice by using the number buttons [0]–[9], [+], [-].
After selecting the Song and playing it, press and hold the [VOICE] button for longer than a second.
“SONG MELODY VOICE” appears in the display for a few seconds, the selected Voice replaces the Song’s origi-
nal melody Voice.
Listening to the Demo Songs
BGM Playback
• You can also set the demo
group in the Function set-
tings (page 30 Function
021).
NOTE
Hold for longer than a second.
• You can select a song by
using the [+] button after
pressing the [DEMO/BGM]
button. The [-] button can be
used to go back to the
beginning of the selected
song.
NOTE
Demo Preset songs (001–003)
Preset All preset songs (001–102)
Random Song Playback
The Random Play mode causes the songs in the group selected for BGM playback to be played back in random
order. (Demo group Songs [Preset Songs 001–003] cannot be played at random.)
The setting of the Random Play mode can be set in the Function settings (page 30 Function 022).