Elite modem requirements, Viii, Elite – Zhone Technologies 08-01002-01 User Manual
Page 10: Modem requirements

viii About this document
Revision 2.01
Elite Modem Installation Guide
08-01002-01
Elite
Modem Requirements
The Elite Modem has specific requirements. Please insure that all of the
information and equipment is available prior to proceeding with the
installation procedure. The requirements are as follows:
If you need help, call distributor technical support.
Requirement
Description
Elite Modem Service
Contact your local Internet service provider (ISP)
and subscribe to high-speed Internet service.
Your modem will not function until the common
local exchange carrier activates the service.
Network Access
A 10Base-T Ethernet Card with a standard RJ-45
connector must be installed and configured in
your computer. Any computer (MAC, PC, UNIX
workstation) that can run Windows 3.1 or OS5 or
higher can be used with the Elite Modem.
Network Address
Internet Protocol (IP) address from your Internet
service provider or corporate IS network
administrator. Simply ask for the IP address
requirements for your connection. Your Internet
service provider must use TCP/IP protocol.
Only one Elite Modem per phone
line
The Elite Modem will not operate with multiple
computers. Only the computer that is directly
connected to the Elite Modem through the
10Base-T Ethernet cable is supported.
Elite Modem must be connected
to line one (1) on multiple line
telephone systems
Data transfer rates will vary somewhat,
depending on the speed of your computer, the
network (ISP, corporate, etc.) through which you
are communicating, and the speed and
connection of the computer with which you are
transferring data.