Yamaha CDC-697 - Manual (Page 7)

3
En
GETTING ST
ARTED
English
■ Battery installation
■ Battery replacement
If you find that the remote control transmitter must be used
closer to the main unit, the batteries are weak. Replace both
batteries with new ones.
Notes
• Use only AA, R6, UM-3 batteries for replacement.
• Be sure the polarities are correct. (See the illustration inside
the battery compartment.)
• Remove the batteries if the remote control transmitter will not
be used for an extended period of time.
• If batteries leak, dispose of them immediately. Avoid
touching the leaked material or letting it come in contact with
clothing, etc. Clean the battery compartment thoroughly
before installing new batteries.
PREPARATIONS
Supplied Accessories
Remote Control Transmitter
■ Remote control transmitter
operation range
Notes
• There should be no large obstacles between the remote
control transmitter and the main unit.
• If the remote control sensor is directly illuminated by strong
lighting (especially an inverter type of fluorescent lamp, etc.),
it might cause the remote control transmitter not to work
correctly. In this case, reposition the main unit to avoid direct
lighting.
2
1
3
NATURAL SOUND COMPACT DISC PLAYER CDC-697
DISC
1 2 3 4 5 STANDBY /ON
POWER
ON OFF
PLAYXCHANGE
30° 30°
Remote control sensor
Within approximately
6 m (19.7 feet)
SYNCHRO DIMMER
STANDBY/ON
PEAK
PROG CLEAR TAPE
3 2 1
6 5 4
9 8 7
INDEX +10 0
OUTPUT LEVEL MODE
DISC SCAN
REPEAT
CDC8 WH26170
RANDOM
DISC SKIP
+ -
OPEN/
CLOSE
TEXT/ TIME
Remote Control Transmitter Batteries (AA, R6, UM-3) x 2
Audio Pin Cable
Power cable
(U.S.A., Canada, Australia, U.K. and
Europe models) The shape of the
plug may vary depending on the area
where you purchased.
01_En_02_star_CDC-697_UAB.p65 7/12/06, 13:22 3