Yamaha CDC-697 - Manual (Page 18)

14
En
■ Display information during
programming
1 Shows the program number for the track to be
programmed next.
2 Shows the selected disc and track number.
3 Shows the total time of the tracks currently
programmed.
4 Shows only the numbers of programmed tracks on the
selected disc.
* If “STEP 1” does not appear on the display after the
PROG button is pressed, press the TEXT/TIME display
mode-select button.
* If the total time exceeds 99 minutes and 59 seconds, the
time will not be displayed.
Notes
• You can program as many as 40 tracks at one time.
• You can program a whole disc by pressing “0”, instead of one
track. At that time, “ALL” lights up in the display.
• The total time of the programmed tracks will not be
displayed, if a track number higher than 20 is programmed.
• If, during programming, the TEXT/TIME display mode-
select button is pressed, the program number display can be
changed to display the total time of the programmed tracks or
no information. To return to the previous display, press the
TEXT/TIME display mode-select button once again.
• The t and y buttons can be used during playback, but
only within the range of the programmed tracks.
• Pressing a numeric button stops the current program and
skips to the beginning of the track of the number pressed.
Once that track has finished playback, the previously
interrupted program resumes playback.
• The e and r buttons can be used during playback to
search all tracks, including unprogrammed tracks.
■ To stop program play
Press the a button. The first programmed track number will
be displayed.
To resume playback, press the w button. Playback will start
from the beginning of the program.
■ To cancel a programmed sequence
There are several methods, as described below.
•
Press the a button or the CLEAR button while the unit
is stopped.
• Open the disc tray.
• Press the STANDBY/ON button.
• Switch off the power.
■ To check program data
1 During program play, press the a button.
2 Press the
PROG button.
3 Each time the y button is pressed, the track numbers
and sequential order of the programmed tracks can be
checked one after another. The display of the track
number can be returned (sequentially in reverse order) by
pressing the t button.
■ To correct program data
1 Follow the procedure described in “To check program
data”.
2 Display the track number to be corrected by pressing the
t or y button.
3 Press a numeric button to select a track to replace the one
displayed. The previously programmed track will be
cleared from the memory and the new one will be
programmed.
4 After the correction has been completed, press the
PROG button or w button once again.
- - S T E P 1
1 2 3 4 5
SEARCH
1DISC
5DISCS
TITLE
REP RNDM SAVE BEST EDIT FILE
S F PROG CD- TEXT
ARTIST TRACK 1 2 3 4 5
6 7 8 9 10
11 12 13 14 15
16 17 18 19 20
1
- 6 S T E 3 : 2 5
1 2 3 4 5
SEARCH
1DISC
5DISCS
TITLE
REP RNDM SAVE BEST EDIT FILE
S F PROG CD- TEXT
ARTIST TRACK 1 2 3 4 5
6 7 8 9
11 12 13 14 15
16 17 18 19 20
3
4 2
VARIOUS FUNCTIONS
01_En_03_play_CDC-697_UAB.p65 7/12/06, 13:22 14