Yamaha RX-V595aRDS - Manual (Page 28)

28
3 2
1
AUTOMATIC TUNING
TUNING
Quick automatic-search tuning (AUTOMATIC TUNING) is effective when station signals are strong and there is no interference.
However, if the signal from the station you want to select is weak, you must tune in to it manually (MANUAL TUNING).
MANUAL TUNING
Check that the “AUTO
TUNING” indicator goes off.
Set the SELECTOR DIAL to the AMP/TUN position on the remote control and select TUNER as the input source.
1
Select the reception band (FM or AM) and confirm it on
the display.
Front panel
or
2
Press TUNING MODE so that the “AUTO TUNING”
indicator lights up on the display.
Front panel
Lights up
3
To tune in to a higher frequency, press the UP side of
TUNING once.
To tune in to a lower frequency, press the DOWN side
of TUNING once.
Front panel
* If the station where the tuning search stops is not the
desired one, press once more.
* If the tuning search does not stop at the desired station
(because the signal from the station is weak), take the
manual tuning procedure.
1
Select the reception band (FM or AM) and confirm it on
the display.
Front panel
or
2
Press TUNING MODE.
Front panel
3
Tune in manually to the desired station.
Front panel
* To continue the tuning search, press and hold the button.
Notes
• If you tune in manually to an FM station, it will be automati-
cally received in monaural mode to increase the signal
quality.
• When tuned in to a station, the frequency of the received
station is shown on the display. If an RDS station that
employs the PS data service is being received, the station
name is also shown on the display.
01RX-V595aRDS-3 6/24/99, 11:00 AM 28