Zanussi ZBP 1165 - Manual (Page 27)

2 7
Something not working
If the oven is not working correctly, please carry out the following checks, before contacting your local Service Centre.
IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation,
a charge will be made even if the appliance is under guarantee.
SYMPTOM
The oven does not come on.
The oven light does not come on.
It takes too long to finish the dishes, or they are
cooked too fast.
Steam and condensation settle on the food and the
oven cavity.
The electronic programmer does not work.
The oven fan is noisy.
Error code (letter "F" followed by digits) appears on
the control panel.
The display shows "12.00".
SOLUTION
Touch the OVEN ON control, then select a cooking
function.
Check the fuse and ensure the socket switch or the
switch from the mains supply to the oven are ON.
Switch on the oven using push control 1.
Check the light bulb, and replace it if necessary (see
"Replacing the Oven Light")
The temperature may need adjusting
Refer to the cooking function sections and to any
cooking chart provided
Leave dishes inside the oven no longer than 15-20
minutes after the cooking is completed.
Check the instructions for the timer.
Check that shelves and bakeware are not vibrating in
contact with the oven back panel.
Take note of the error code and contact an authorised
Service Centre.
Set the time of day (see chapter "How the set the time
of day").