Yamaha EMX212S - Manual (Page 7)

Quick Guide
BASIC
EMX512SC/EMX312SC/EMX212S 7
We begin by connecting up two speakers and generating some
stereo output. Note that operations and procedures will vary
somewhat according to the input devices you are using.
1
Connect up the speakers and your input devices
(microphones, instruments, etc.)
Use non-powered speakers and dedicated speaker cable. Connect one speaker
to SPEAKERS jack A (A1 or A2), and the other to jack B (B1 or B2). Then con-
nect your input devices (microphones, guitar, etc.) to the appropriate input jacks
on the top panel. For details, see page 30.
RIGHT WRONG!!
Getting Sound to the Speakers
1
2,8
4
6
2,7,9
3
5
1
NOTE
We recommend that you do not
connect electric instruments
(such as electric guitars and
basses) directly to the EMX.
Instead, these instruments
should be connected through
an intermediary device such as
a direct box, a preamp (guitar
amp), or an amp simulator.
Before connecting input
devices to the EMX, be sure
that all of these devices (includ-
ing microphones) are powered
off. And before turning the
power to any device on or off,
be sure to turn the volume of
that device all the way down.
Neglect of these precautions
may result in large noise bursts
that may damage your equip-
ment, your ears, or both.
Never connect both A and B
jacks to a single speaker. Con-
nection of both jacks to the
same speaker may result in
damage to the mixer.