Zebra Technologies P100iTM - Manual (Page 46)

42 P100i User’s Manual 980590-001 Rev. A
Cleaning
Cleaning the System
How to Clean
1. Leave power on.
2. Press and hold the Multi-Function Control Button for 5 seconds.
3. When the cleaning cycle is initiated, the LCD message REMOVE RIBBON THEN
CLOSE LID will display.
4. If the lid is opened and closed without removing the ribbon, the message REMOVE
RIBBON THEN CLOSE LID will remain.
5. After the ribbon is removed and the lid is closed, the messages CHECKING RIBBON and
CLEANING CYCLE will display.
6. The message FEED LONG CLEANING CARD IN EXIT will display. When the card
sensor registers the presence of the cleaning card, the rollers should take the card into
the printer.
7. The message CLEANING HEAD will display.
8. The message CLEANING ROLLERS will display.
9. When the cleaning process is done, the printer will eject the cleaning card. If the card
sensor still senses the cleaning card, the message
REMOVE LONG CLEANING CARD
will display.
10. After the card is removed, the LCD will display READY . You may now reload the ribbon
and continue printing.
Printer Path
Cleaning Card
Multi-Function
Control Button
Multi-Function
LCD Panel