Remote control features, Setting the manufacturer code, Precautions when performing the setting – Yamaha AVX-S80 User Manual

Page 36: Keep pressing code set between step 1 and 2

OPERATING OTHER COMPONENTS USING THE REMOTE CONTROL

Setting the manufacturer code (remote control signal
assigned to each manufacturer) for your TV, VCR or
DVD player on the remote control allows you to operate
not only the AVX-S80 but also your TV, VCR or DVD
player using the remote control.

Note

• Depending on the model, certain components from other

manufacturers cannot be controlled, or only limited functions
can be controlled, even though the proper manufacturer code
has been set. If you encounter this problem, please use the
remote control supplied with the component.

Setting the manufacturer code

Manufacturer codes can be set for TV, VCR and DVD/CD
buttons only.

Note

• TV manufacturer codes can be set for the TV button only.

However, any of the manufacturer codes can be set for the VCR
and DVD/CD buttons.

While pressing CODE SET, press the input
selector button (TV, VCR, DVD/CD) for which
the manufacturer code is to be set.

Only one manufacturer code can be set for each input
selector button.

Note

• Keep pressing CODE SET between step 1 and 2.

• Refer to “LIST OF MANUFACTURER’S

CODES” at the end of this manual.

Keeping CODE SET pressed, enter the 1-
digit device code and the 2-digit
manufacturer code for the component to be
controlled using the numeric buttons.

You can release CODE SET after entering the code.

• The manufacturer code 99 has been set for the remote control

selector buttons (TV, VCR and DVD/CD) at the factory.

Press POWER (TV or AV) and check that the
component to be controlled turns on and off
(standby).

Precautions when performing the setting

You can operate the component using the TV, VCR or
DVD player operation buttons on the remote control once
the manufacturer code is set properly. If unsuccessful,
perform the procedure from step 1 again. Pay attention to
the following points when you perform the procedure.
• Check that the correct remote control selector button

has been selected when setting the manufacturer code.

• If more than one code is given for a manufacturer, try

entering each code in the order given.

• Remove and replace the remote control’s batteries

(complete this step within 2 minutes) and then perform
the procedure. While replacing the batteries, be sure not
to press any button on the remote control. Doing so
may erase the manufacturer code which has been set
for other remote control selector buttons.

To reset the manufacturer code to the
factory-set code

Follow steps 1 to 2 for the procedure “Setting the
manufacturer code”, and enter the device code for the
component and “99” while pressing CODE SET in step 2.
(It is not necessary to follow step 3.)

AUDIO

POWER

TV MODE

POWER

TUNER

VCR

VIDEO 2

VIDEO 1

ENTERTAINMENT

ROCK

JAZZ

HALL

MOVIE 2

MOVIE 1

MONO MOVIE

SPORTS

STEREO

MATRIX 6.1

SELECT

/DTS

CANCEL

CODE SET

SLEEP

INPUT

VOL

MUTE

SUBTITLE

REC

TOP MENU

MENU

LEVEL

SET MENU

TEST

B.BOOST

ON SCREEN

RETURN

ABCDE

MUTE

VOL

PRESET

ENTER

DVD

AMP

CODE SET

DVD/CD

VCR

Numeric buttons

(U.S.A. model)

E7-S80-32-34(5.8)a

02.6.29, 4:34 AM