Yamaha AVX-S80 - Manual (Page 30)

26
RECORDING
Recording adjustments and other operations are
performed from the recording components. Refer to the
operation instructions for these components.
1 Turn on the power of this system and all
connected component.
2 Select the source component you want to
record from.
The procedure for selecting an input source is the
same as the one described in “BASIC PLAYBACK”
on page 19.
3 Start playback (or select a broadcast station)
on the source component.
4 Start recording on the recording component.
Notes
• Do a test recording before you start an actual recording.
• When this system is set in the standby mode, you cannot record
between the components connected to this system.
• The setting of BASS BOOST, VOLUME, “5 L/R BALANCE”
on the SET MENU and DSP programs does not effect the
recorded material.
• The signal input from VCR IN is not output to VCR OUT.
• Check the copyright laws in your country to record from
records, CDs, radio, etc. Recording of copyrighted material
may infringe copyright laws.
• It is not possible to record the sound effect created by this
system’s DSP processing.
If you playback a video source that uses scrambled or
encoded signals to prevent it from being dubbed, the
picture itself may be disturbed due to those signals.
■
Timer playback/recording
This system can perform playback or recording with an
external timer (not supplied). Refer to the operating
instructions for the component and the timer to be used.
Notes
• Stored data, such as input source, will be reflected when
playback or recording with the timer.
• If you do not want any sound output when recording with a
timer, turn the volume down.
E4-S80-19-26(6.29)b 02.6.29, 4:33 AM 26