Yamaha YSP-1000 - Manual (Page 86)

82
ADJUSTING SYSTEM PARAMETERS
4
Press / to switch between PROTECT: ON
and PROTECT: OFF.
• Select PROTECT: ON to activate the protection
feature.
• Select PROTECT: OFF to deactivate the protection
feature.
5
Press STANDBY/ON on the front panel or on
the remote control to set this unit to the
standby mode.
The new setting will be activated when you turn on
the power of this unit next time.
You can reset all of the parameters of this unit to the
factory presets. This procedure completely resets ALL the
parameters in SET MENU.
After performing the following procedure you must reset the
ROOM TYPE, SP POSITION and ROOM SIZE parameters to
match your surround sound environment.
1
Repeat steps 1 to 3 in “Setting the maximum
volume level” on page 80.
2
Press / on the remote control so that
FACTORY PRESET is shown in the front
panel display.
3
Press ENTER.
ENTER
VOL
PROTECT: ON
VOL
PROTECT: OFF
STANDBY/ON
or
Front panel Remote control
Initializing the current settings
Note
ENTER
VOL
FACTORY PRESET
ENTER