beautypg.com

Quick reference guide, Ysp-1000 quick reference guide, Before installing this unit installing this unit – Yamaha YSP-1000 User Manual

Page 105: Connecting external components to this unit, Connecting a tv and a dvd player, Installing the optimizer microphone, This unit dvd player tv, Subwoofer

background image

Printed in Malaysia

WG29110

© 2005 All rights reserved.

This quick reference guide explains steps to connect a TV and a DVD player to this unit and achieve the surround sound effects in a quick, easy manner.

This unit creates surround sound by reflecting projected sound beams off the walls of your listening room.
The surround sound effects produced by this unit may not be sufficient when the unit is installed in the following locations.
• Rooms with surfaces inadequate for reflecting sound beams
• Rooms with acoustically absorbent surfaces
• Rooms with measurements outside the following range W (3 to 7 m) x H (2 to 3.5 m) x D (3 to 7 m)
• Rooms with less than 2 m from the listening position to the speaker positions
• Rooms where objects such as furniture are likely to obstruct the path of sound beams
• Rooms where the listening position is close to the walls
• Rooms where the listening position is not in front of this unit
Make sure you leave an adequate amount of ventilation space so that heat can escape. Make at least 5 cm of space above or below this unit.

Install this unit where there are no obstacles such as furniture obstructing the path of sound beams. Otherwise, the desired surround sound effects may not be achieved.
You may install this unit in parallel with the wall or in the corner.

Connect this unit to external components such as your TV, DVD player, VCR, digital satellite tuner, cable TV tuner, game console and a subwoofer.

Connecting a TV and a DVD player

Connect a TV and a DVD player to this unit. If you connect a subwoofer to this unit, you can enjoy reinforced low bass sounds.

For further information on connecting other components, see pages 15 to 23 in the supplied Owner’s Manual.

Installing the optimizer microphone

Use a tripod or the supplied cardboard microphone stand to place the optimizer microphone at the same height as your ears would be when you are seated in your listening position.

Be sure to place the optimizer microphone on an imaginary center line drawn from this unit.

y

Check the following points before starting the AUTO SETUP procedure.
• Is the optimizer microphone firmly connected to this unit?
• Is the optimizer microphone placed in a proper location?
• Are there any large obstacles in between the optimizer microphone and the walls in your listening room?

Before installing this unit

Installing this unit

YSP-1000 QUICK REFERENCE GUIDE

5 cm or more

Rear

Front

Side view

Side

40° to 50°

An object, such as furniture

Corner installation

Install this unit in the corner at a 40º to 50º angle from
the adjacent walls.

An object, such as furniture

Parallel installation

Install this unit in the exact center of the wall when it
is measured from the left and right corners.

Installation example
Install this unit so that the sound beams
can be reflected off the walls.

Wrong

Correct

Correct

Connecting external components to this unit

Note

Note

REMOTE IN

RS-232C

VIDEO OUT

VIDEO IN

AUDIO IN

OPTICAL

DIGITAL IN

VCR

VCR

STB

AUX

DVD/AUX

DVD

COAXIAL

TV/STB

TV/STB

SUBWOOFER

COMPONENT

COMPONENT

COMPONENT

R

L

Rear panel of this unit

This unit

DVD player

TV

Optimizer microphone (supplied)

Coaxial

digital

output

Video

output

Video

input

Analog

audio

output

Optical

digital

output

Video pin cable

Subwoofer pin cable

(in case you connect a subwoofer)

Digital audio pin cable

(supplied)

To the AC outlet

Audio pin cable (supplied)

Optical cable (supplied)

(in case of an optical digital connection)

Subwoofer

Monaural

input

Component

video

output

Component

video

input

Component video pin cable

Video pin cable (supplied)

* Component video pin cable

*

If your TV has component video input jacks, connect
the component video input jacks of your TV to the
COMPONENT VIDEO OUT jacks of this unit in
addition to the composite video connection.

Note

Using the supplied cardboard microphone stand

Using a tripod

Optimizer microphone position

More than 2 m

Within 1 m

Within 1 m

Tripod

Optimizer microphone position

Within 1 m

Within 1 m

Cardboard
microphone stand

More than 2 m

Imaginary
center line

Imaginary
center line

YSP-1000 Quick Reference Guide.fm Page 1 Tuesday, August 30, 2005 6:58 PM