Yamaha RX-V565 User Manual
Page 51
47
En
Troubleshooting
English
INTR
ODUCTION
APPENDIX
PRE
P
ARA
T
ION
BA
S
IC
OPERA
T
ION
AD
V
ANCED
OPERA
T
ION
No picture.
An appropriate video input is not selected
on the monitor.
Select an appropriate video input on the monitor.
—
The composite output terminals are used
to output a component video signal, or the
COMPONENT VIDEO jacks are used to
output a composite video signal.
If your monitor does not support the HDMI
connection, connect it to the COMPONENT OUT
jacks or the composite output terminals and select an
appropriate video input on the monitor.
This unit outputs the video signals are not
supported on the video monitor connected
to the HDMI OUT jack.
Displays the advanced setup menu and select
“VIDEO” in “INIT” to reset the video parameters.
Displays the advanced setup menu and set
“MON.CHK” to “YES.”
Non-standard video signals are input.
Connect the monitor to this unit via the
COMPONENT OUT jacks or the composite output
terminals.
The sound suddenly
goes off.
The protection circuitry has been activated
because of a short circuit, etc.
Check that the speaker impedance setting is correct.
Check that the speaker wires are not touching each
other and then turn this unit back on.
—
The sleep timer has turned off this unit.
Turn on this unit, and play the source again.
—
Sound is heard from
the speaker on one
side only.
The playback component or speakers are
not connected properly.
Connect the cables properly. If the problem persists,
the cables may be defective.
The speaker level settings are incorrect.
Adjust “B)Level” settings.
Only the center
speaker outputs
substantial sound.
When a monaural source sound field
program is applied, sound of all channels
are output from the center speaker for
some surround decoders.
Try another sound field program.
No sound is output
from a specific
speaker.
Output from that speaker is disabled.
Check the Speaker indicators on the front panel
display. If the corresponding indicator is turned off,
try the following.
1) Change the input source to another one.
2) With the selected sound field program, sound is not
output from that speaker. Select another sound field
program.
3) “None” may have been selected for that speaker on
this unit. Display Speaker Setup in the Setup menu
and enables output of that speaker.
The volume of that speaker is set to
minimum in Speaker Setup in the Setup
menu.
Display Speaker Setup in the Setup menu and adjust
the volume (Manual Setup
→B)Level).
This unit or speaker is malfunction.
Check the Speaker indicators on the front panel
display. If the corresponding indicator lights up,
connect another speaker and check if sound is output.
If sound is not output, this unit may be malfunction.
No sound is heard
from the surround
speakers.
This unit is in the “STRAIGHT” mode
and a monaural source is being played
back.
Press LSTRAIGHT or the jSTRAIGHT on the
remote control to turn off the “STRAIGHT” mode.
Sound may not be output from certain
channels depending on input sources or
sound field programs.
Try another sound field program.
Problem
Cause
Remedy
See
page