beautypg.com

Operation 11, Important, Warning – Woods Equipment RD72 User Manual

Page 11

background image

Operation 11

MAN0260 (Rev. 1/12/2007)

Figure 2. Attachment Points

Figure 3. Attach Mower to Tractor

Adjust Cutting Height

„

Keep all persons away from operator control

area while performing adjustments, service, or
maintenance.

IMPORTANT

Avoid low cutting heights. Striking the ground

with blades produces one of the most damaging
shock loads a mower can encounter. Allowing
blades to contact ground repeatedly will cause
damage to mower and drive.

1. Level mower from side to side. Check by

measuring distance from mower frame to the
ground at each deck rail.

2. Verify that the same amount of spacers are under

all caster arms.

3. Control cutting height by adjusting front and rear

caster wheels.

4. To raise rear of mower, move caster adjustment

spacers under rear caster arms.

5. To raise front of mower, move spacers under front

caster wheel arms.

Tractor Top Link Adjustment

When the cutting height is set, adjust tractor top link
until mower top link attachment point (A), Figure 4, is
aligned vertically with mower hitch pin (B). The front
tires of the mower will lift off the ground before the rear
tires when the unit is raised. This will allow the mower
to follow the ground contour.

Figure 4. Top Link Adjustment

RDC54 Only

The RDC54 has two mower hitch plate attachment
points (D). It may be necessary to change the mower

1. Tractor Top Link

A. Mower Top Link Attachment Point

B. Mower Hitch Pin

CM906

Tether Chain

WARNING

Table 1: Cutting Height Chart

Spacers Required Under

Caster Arm Pivot Tube

Cut Height

1/2" Spacer

1" Spacer

1"

0

0

1-1/2"

1

0

2"

0

1

2-1/2"

1

1

3"

0

2

3-1/2"

1

2

4"

0

3

4-1/2"

1

3

A. Mower top link attachment point

B. Mower hitch pin

C. Tractor top link

D. Mower hitch plate attach-
ment point