Windsor High Speed Burnisher LB2000IA - Manual (Page 10)

TECHNICAL SPECIFICATIONS
86309600 (2000) BURNISHER 10/08/08
3-1
ITEM DIMENSION/CAPACITY
Construction Heavy-duty die cast aluminum deck with heavy-duty rubber
bumper, tubular steel self adjusting handle with die cast aluminum
handle housing.
Motor 1.5 hp
Transmission Direct drive from motor shaft.
Pad speed 2000 rpm
Electrical system:
LB2000I, LB2000IA
230 volts, 50Hz
LB2000, UB2000F 115 volts, 60Hz
Cable 75’ [22.9 m]
Switches Dual levers with safety lock.
Pad Holder ∅20” [50.8 cm] flexible disc
Wheels Four
∅5” [∅12.7 cm], 1.25” [3.2 cm] wide, non-marking tread.
Handle
∅1.5” [∅3.8 cm] tubular steel, self adjusting handle consistently
maintains full contact with the floor, and easy to use thumb
activated safety lock.
Dimensions (L x W x H) 32” [81.3 cm] X 23.9” [60.2 cm] X 48.4” [122.9 cm]
Pad size (See note) 20” diameter x 1” thick
NOTE: Always use a pad, which has been designed for electric ultra high speed burnishing of at
least 2000 rpm.
The sound pressure level at the operator’s ear was measured to be 70 dBA. This was a nearfield,
broad-band measurement taken in a typical industrial environment on a tile floor. This appliance
contains no possible source of impact noise. The instantaneous sound pressure level is below 63 Pa.