Wells OC-2HG User Manual
Page 19
F1
Relay closed or relay ohms low when not cooking
F2
Actual temperature greater than T-SET MAX +60ºF (±35ºF)
F3
Open temperature sensor
F4
Shorted temperature sensor
F5
Relay open or relay ohms high when cooking
F6
No 60 Hz (Cycles per second other than 60 Hz detected)
TROUBLESHOOTING SUGGESTIONS
17
NOTE: There are no user
serviceable components in
the appliance. In all cases
of damage or component
malfunction, contact your
Authorized Wells Service
Agency for repairs.
CAUTION:
ELECTRICAL SHOCK HAZARD
Removal of any cabinet panel will result in exposed electrical
circuits. Any procedure requiring the removal of any cabinet
panel must be performed by a qualified technician only.
CAUTION:
ELECTRICAL SHOCK HAZARD
Fuse replacement may expose dangerous voltages.
Fuse replacement must be performed by a qualified technician.
SYMPTOM
POSSIBLE CAUSE
SUGGESTED REMEDY
No power to appliance
Circuit breaker off or tripped
Reset circuit breaker
Power cord unplugged or
damaged
Check power cord
Plug in or repair as required
Fuse blown or loose
Check power fuses. If blown,
correct problem and replace
fuses
Oven will not heat
Power switch turned to OFF or
FAN
Turn power switch ON
Temperature control not set
Set to desired temperature
Fan switch OFF
Turn fan switch to HIGH or LOW
Oven door not closed
Be sure door is closed and
latched
Hi-limit control tripped on
excessive oven temperature
Allow oven to cool
Hi-limit will reset
Damaged controller or internal
components
Contact Authorized Wells
Service Agency for repairs
Door pops open during cook
cycle
Hinge out of adjustment
Adjust hinge
Griddle will not heat
Temperature control not set
Set to desired temperature
Damaged controller or internal
components
Contact Authorized Wells
Service Agency for repairs
Griddle heats unevenly
Damaged controller or internal
components
Contact Authorized Wells
Service Agency for repairs
Temperature control(s) not set
Set to desired temperature
Damaged controller or internal
components
Contact Authorized Wells
Service Agency for repairs
One or both hotplates will not
heat
ERROR CODES
In all instances of controller error,
contact your Authorized Wells
Service Agency for repairs.
272
304
621
Op
M
OC-2HG
Combo Cook Center