Net and tracert utilities, User log-on accounts, Creating a new user account – Wyse Technology TM 9000 Series User Manual
Page 64: Net and tracert utilities 52 user log-on accounts, Creating a new user account 52, Winping window
52
Figure 30 WinPing window
WinPing is used to:
• Determine the status of the network and various hosts.
• Track and isolate hardware and software problems.
• Test, measure, and manage networks.
• Determine the IP address of a host if only the host name is known.
Net and Tracert Utilities
Net and Tracert utilities are available for administrative use. For more information on these
utilities, go
.
User Log-on Accounts
Administrators can create new users and configure user profiles.
By default, a new user is only a member of the Users group and is not locked down. You,
as the administrator, must select the attributes and profile settings for a new user.
Caution
By default, all application settings are set to cache to C drive. It is highly
recommended that you cache to the Ramdisk Z drive (as is pre-set in the
User and Administrator accounts) to avoid overflowing the Write Filter cache.
Creating a New User Account
New user accounts can be created by using the User Manager utility. You must be
logged-on as an administrator to create new user accounts. You can create user accounts
locally or remotely through VNC. However, due to local flash/disk space constraints, the
number of additional users should be kept to a minimum.