WhisperKool 5000 - Manual (Page 8)

Page 6 EXti 110111
Evaporator and Condenser Fan
•
•
•
•
ALARM Pre-Chill Display
Control “ON/OFF” Button
•Turns the Cooling Unit
“ON/OFF”
1
Anti Frost Compressor
Energy Reduction
Hi Bottle Temp History & Scroll
Button 1
Low Bottle Temp History & Scroll
Button
Push to see the min. stored temperature.
In programming mode use to browse the
parameter codes or decrease
the displayed value.
1
Energy Saving
Button
1
Cellar “Pre-Chill” Button 3-5
Push to see the max stored temperature.
In programming mode use to browse the
parameter codes or increase the display
value. Hold for 3 seconds to start fast
freezing cycle.
Set Button
View Set Point 1
Change Set Point 3-5
SET + Down = CPSM 10-15
Reset Hi & Lo Button 3-5
Display and modify set point. In
programming mode it selects a
parameter confirms an opera-
tion. Hold for 3 seconds when
the min or max temperature is
displayed to RESET.
Evaporator and Condenser Fan
Set Button
•View Set Point 1
•Change Set Point 3-5
•SET + Down = CPSM 3 - 5
•Reset Hi & Lo Button
3-5
ALARM Pre-Chill Display
Control “ON/OFF” Button
•Turns the Cooling Unit
“ON/OFF”
1
Anti Frost Compressor
Hi Bottle Temp History & Scroll
Button 1
Cellar “Pre-Chill” Button 3-5
Low Bottle Temp History & Scroll
Button
Push to see the min. stored temperature.
In programming mode use to browse the
parameter codes or decrease
the displayed value.
1
Inactive
Display and modify set point. In
programming mode it selects a
parameter confirms an opera-
tion. Hold for 3 seconds when
the min or max temperature is
displayed to RESET.
Push to see the max stored temperature.
In programming mode use to browse the
parameter codes or increase the display
value. Hold for 3 seconds to start fast
freezing cycle.
QUICK REFERENCE GUIDE
Standard Controller Layout
*If your unit is installed through the wall and does not have a remote keypad you have the Standard Controller*
Remote Controller Layout
*If your unit has a remote keypad then you have the Remote Controller*
Note: The 1 or 3-5 qualifies the amount of time in seconds that the button must be pushed to activate the feature.
Refer to page 30 for complete listing of buttons and symbols.
Note: The 1 or 3-5 qualifies the amount of time in seconds that the button must be pushed to activate the feature.
Refer to page 34 for complete listing of buttons and symbols.