WhisperKool 5000 - Manual (Page 18)

Page 16 EXti 110111
PREPARING THE SYSTEM FOR INSTALLATION
5000 / 5000
Applying Insulation Tape
Locate the (4) precut pieces of black foam tape included with the system, two larger
pieces and two smaller pieces. To apply, simply peel back the white-paper adhesive cov-
ering and place on the mounting bracket. The large pieces are applied to the top and
bottom while the smaller pieces are for the sides. This foam creates a tight seal between
the bracket and the wall.
Single Piece Mounting Bracket
The 5000ti/tiR utilizes a single piece mounting bracket, this sturdy bracket frames the in-
stallation location and secures the unit to the wall. WhisperKOOL has also designed the
bracket to hold the system at a 2º degree angle, this helps project the air into the space
and aids in condensation drainage.
Mounting Bracket Installation
Select your desired bracket mounting location (see diagram below), this location determines the depth of the instal-
lation. For example, position #1 keeps most of the system out of the cellar while position #4 makes the back of the
system near flush on the exterior wall. Slide bracket onto unit, pay special attention to the TOP label on the bracket
and the flanges for mounting to the unit are towards the back. Use the (4) supplied 1/2” self tapping screws to fasten
the bracket to the unit. It is imperative to not use self tapping screws longer than 1/2” in length.
If you are installing through an exterior wall, please review page 18 for
specific instructions on exterior grill installation.
7.5-8.5” inches In Cellar # 1
# 2
# 3
# 4
11.5-12.5” inches In Cellar
15.5-16.5” inches In Cellar
19.5-20.5” inches In Cellar
5” inch thick wall
(wall thickness may vary) Mounting Bracket
Wine Cellar Exhaust Area