Windsor Saber Glide SG36 - Manual (Page 40)

MAINTENANCE
86037580 GLIDE 01/03/07 4-17
SERVICE SCHEDULE
MAINTENANCE BEFORE EACH
WORK PERIOD
AFTER EACH
WORK PERIOD
50
HRS
100
HRS
200
HRS
Check water level of batteries after charging;
add distilled water if necessary
*
Check that recovery tank cover seals tightly *
Visually check for damaged or worn tires *
Check brushes or pads for proper installation *
Check vacuum hose connections *
Check that squeegee is securely attached
and properly adjusted
*
Check that side squeegees are properly
adjusted
*
Check for securely attached drain hose, plug
and caps
*
Check brakes and steering for proper
operation
*
Inspect vacuum filter for debris *
Clean out solution tank and filter, check flow *
Run vacuum motors to dry *
Clean brushes or pads and check wear *
Clean main and side squeegee blades and
check wear *
Clean out recovery tank and vacuum filter *
Clean and inspect float shutoff *
Clean outside of tanks, check for damage *
Store with covers off tanks *
Charge batteries *
Check side squeegee for wear *
Clean off top of batteries *
Check battery cells with hydrometer *
Inspect scrub deck skirts *
Clean solution strainers *
Check battery connections are tight *
Clean battery cases and battery
compartment *
Check parking brake adjustment *
Check brakes discs and calipers for damage
or wear
*
Clean pivot points on squeegee and scrub
deck
*
Check all motors for carbon brush wear *
Check motor commutators *
Check steering chain tensioner *
NOTE: Traction drive, wheels and batteries should be serviced based on traction drive hour meter. The
scrub brush hour meter should be used for all other service schedule items.