Windsor Saber Glide SG36 - Manual (Page 38)

TRANSPORTING MACHINE
86037580 GLIDE 01/03/07 4-15
TOWING OR PUSHING MACHINE
The machine may be towed for short distances at
speeds not to exceed 5 mph. Be careful to avoid
damaging machine. Attach towing device at tie
down point. The machine may be pushed by hand
from the rear.
NOTE: To avoid damage caused by regenerative
voltage, disconnect traction motor before towing or
pushing machine.
MACHINE TIE-DOWNS
There are two tie points located at the rear, side of
the machine frame and two at the front corners. Tie-
down devices must be of the proper type and
strength. The combined strength of all tie-downs
must be strong enough to lift two times the weight of
the machine. Tie-downs must be positioned to
prevent the machine from moving forward,
backward, or either side to side. Use all four corners
of the machine with the tie-downs running out
opposite directions. Tie-downs must be attached to
the transporting vehicle securely.
PREPARATION FOR TRANSPORTING
Remove squeegee tool to eliminate interference with
tie-downs.
Scrub head must be in the up position before
loading.
NOTE: When transporting the machine on a trailer
or in a truck, in addition to using tie-downs, be sure
to set the parking brake, and block the tires to
prevent the machine from rolling.