Wasp Bar Code Wasp WPL606 - Manual (Page 12)

Figure 6: Ribbon under Pint Had
6. Pull the paper core up to the rewind spindle and slide it on. Slide both the
ribbon and rewind spindle all the way to be flush with the case side of the
spindle. The Wasp logo will face up again
Figure 7: Ribbon placed onto Rewind Spindle
7. Roll the rewind spindle by hand until some of the actual ribbon shows in the
front of the printer. The Wasp logo will roll over the top of the spindle.
Flush with
Case
Ribbon in
front
Figure 8: Ribbon wound into printing position
8. The ribbon must route above the black ribbon sensor.
Ribbon
Ribbon
Sensor
Figure 9: Ribbon Sensor and Ribon placement
8