beautypg.com

Installation instructions, Warning, Unpack the air conditioner – Whirlpool 1187361 User Manual

Page 5: Smart-mount, Tray installation

background image

5

INSTALLATION INSTRUCTIONS

Unpack the Air Conditioner

Remove packaging materials

Remove and properly dispose of packaging materials.
Remove tape and glue residue from surfaces before turning
on the air conditioner. Rub a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water
and dry.

Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your air conditioner.

SMART-MOUNT

Tray Installation

1. Using the tray back as a template, center in windowsill

against outside edge of stool.

2. Using the 2 inside screw holes in tray back, mark screw

locations on windowsill for mounting the SMART-MOUNT

tray.

3. Remove tray back. Using these marks, drill

³⁄₃₂ in. pilot holes

in the windowsill approximately 1

¹⁄₂ in. deep.

4. To assemble the tray frame, insert tab on tray back into slot

on tray side. Check to see that the tab is engaged and the
2 pieces are aligned. Insert 2 - #8 - 18 x

¹⁄₄ in. hex-head

screws to secure.

5. Repeat with other tray side.

Excessive Weight Hazard

Use two or more people to move and install
air conditioner.

WARNING

Failure to do so can result in back or other injury.

1. Tray back
2. Windowsill
3. Outside edge of stool

1. Tray back
2. #8 - 18 x

¹⁄₄ in. hex-head screws

3. Tray side

3

2

1

1

2

3