Whirlpool 1187361 - Manual (Page 11)

11
Mode
1. Press MODE until you see the indicator light come on for the
setting you desire.
2. Choose AUTO, COOL, FAN ONLY or POWER SAVER.
■ Auto - Cools room while it automatically controls fan
speed. You cannot change fan speed, but you can adjust
temperature by pressing the plus or minus button.
■ Cool - Cools room. You can select fan speed by pressing
Fan Speed. You can then adjust temperature by pressing
the plus or minus button.
■ Fan Only - Only the fan runs. Display shows “FO”
(fan only).
NOTE: Fan runs on Turbo speed only.
■ Power Saver - Fan runs only when cooling is needed. Fan
stops running when the room temperature matches the
Temperature control setting.
Since the fan does not circulate the room air continuously,
less energy is used, but the room air is not circulated as
often. Use Power Saver when you are asleep or away
from home.
Fan Speed
NOTE: The Fan Speed button will operate only when Cool or
Power Saver mode has been selected.
1. Press FAN SPEED until you see the indicator light come on
for the setting you desire.
2. Choose TURBO, HIGH or LOW.
Temperature
■ Press the plus button to raise the temperature. Each time you
press or hold the plus button, the temperature will go up
1º until it reaches 86°F (30°C).
■ Press the minus button to lower the temperature. Each time
you press or hold the minus button, the temperature will go
down 1º until it reaches 64°F (18°C).
To change the temperature display from °F to °C:
1. Turn off the air conditioner.
2. While the air conditioner is off, press and hold down the
MODE and FAN SPEED buttons while pressing POWER to
turn the air conditioner on.
NOTE: Follow these same steps to change the temperature
display from °C to °F.
Timer delay
To set the Timer for a 1- to 24-hour delay until the air
conditioner turns off (the air conditioner must be On):
1. Press TIMER. Indicator light will flash.
2. Press the plus or minus button to adjust the delay time (1 to
24 hours).
3. Press TIMER again or wait 10 seconds. Indicator light will
remain on.
To set the Timer to turn on the air conditioner, keeping
previous settings:
1. Turn off air conditioner.
2. Press TIMER. Indicator light will flash.
3. Press the plus or minus button to change delay time (1 to
24 hours).
4. Press TIMER again or wait 10 seconds. Indicator light will
remain on.
To set the Timer to turn on the air conditioner, changing
the previous settings:
1. Turn air conditioner on.
2. Adjust MODE to Auto, Cool, Fan Only, or Power Saver.
3. Adjust FAN SPEED to Turbo, High or Low.
4. Adjust temperature between 64°F (18ºC) and 86°F (30ºC).
5. Wait 3 seconds before turning off air conditioner.
6. Press TIMER. Indicator light will flash.
7. Press the plus or minus button to change delay time (1 to
24 hours).
8. Press TIMER again or wait 10 seconds. Indicator light will
remain on.
To clear Timer delay program:
NOTE: Air conditioner can be either on or off.
Press and hold TIMER for 3 seconds. Indicator light will shut off.
To see the remaining time (in hours):
1. Press TIMER once after it has been programmed.
2. While the display is showing the remaining time, you can
press the plus or minus button to increase or decrease the
time.