Whirlpool 1187361 - Manual (Page 13)

13
Starting Your Air Conditioner -
Rotary Control
Models without Power Saver
Models with Power Saver
1. Remove clear protective film from front panel badge (on
some models).
2. Set exhaust control. See “Exhaust Control (on some
models).”
3. Select the fan speed. See “Fan Speed.”
4. Select temperature. See “Temperature.”
Exhaust Control (on some models)
Push the Exhaust control CLOSED for maximum continuous
cooling. Pull the Exhaust control OPEN to allow you to draw stale
or smoky air from the room.
■ Open - pull to exhaust room air to the outside
■ Closed - push to circulate room air
The Exhaust control will function only when the Fan Speed
control is operating.
Fan Speed
Set FAN SPEED to the desired setting. When the air conditioner
is operating at Low Cool, High Cool, or Turbo Cool, the fan
circulates air continuously.
■ Turbo Cool - for maximum cooling
■ High Cool - for normal cooling
■ Low Cool - for sleeping comfort
■ Fan Only - to move air continuously without cooling
NOTE: Fan runs on Turbo speed only.
■ Power Saver (on some models) - fan runs only when
cooling is needed. Fan stops circulating air when the
room temperature matches the Temperature control
setting.
Since the fan does not circulate the room air continuously,
less energy is used, but the room air is not circulated as
often. Use Power Saver when you are asleep or away
from home.
NOTE: Fan runs on Low speed only.
Models without Power Saver
Models with Power Saver
Temperature
Turn the TEMPERATURE control to a mid-setting. Adjust the air
conditioner's performance by turning the Temperature control
clockwise for maximum cooling. For less cooling, turn the
TEMPERATURE control counterclockwise. Experiment to find the
setting that suits you best.