Windsor ISCRUB CSE24 10060250 - Manual (Page 58)

MACHINE TROUBLESHOOTING – DELUXE CONTROLLER FAULT CODES
86037660 CHARIOT 05/27/08 4-31
ERROR
CODE
DELUXE PROBLEM SOLUTION
None LCD display on, but incomplete
Disconnect batteries and wait 1 minute before
re-applying power.
0A01 Power down error
Disconnect batteries and wait 1 minute before
re-applying power.
0204 Memory corrupt Replace controller.
All 080_ codes Throttle wiring
Check for short or open circuits in throttle
wiring.
All 140 _ Codes
Check for short circuit between B+ and
traction output.
All 310_ Codes
Possible short circuit of motors, auxiliary
outputs (headlight, recycle pump, or back-
up alarm), wiring or damaged controller Check for short circuits. If code is present
after short circuits are repaired, replace
controller.
7500 LCD module communications timeout
Wiring fault on 6-way serial link between
controller and display.
7501 LCD module settings corrupt
Disconnect batteries and wait 1 minute before
re-applying power.
All 760_ Codes Brush motor or brush circuit fault
Check for short or open circuits in brush
motors or wiring.
All 770_ Codes Vacuum motor or vacuum circuit fault
Check for short or open circuits in vacuum
motor(s) or wiring.
7800 Traction motor open circuit fault
Check for open circuit on propel motor or
wiring.
7801 Traction motor overcurrent error
Check for short circuit on propel motor or
wiring.
7802 Traction motor in power foldback state
Propel motor current has exceeded current
limit for the foldback time.
All 790_ Codes Emergency stop error E-stop input active or wiring fault.
9000 Brush current requirement not satisfied
Check that brushes or pads are installed.
Check for open circuit in scrub lift actuator,
circuit breaker or wiring.