Wayne-Dalton IDRIVE 3982 - Manual (Page 18)

WALL MOUNTING
Depending on location, the light
fi xture may need to be adjusted from
its packaged position.
When mounting on a wall parallel
to the opener, rotate the receiver
module inward to a maximum of
90° until the receiver module is
best aligned with the sending LED.
Mount light to a receptacle and align
the receiving module per previous
instructions.
To mount the light fi xture on a wall
perpendicular to the opener, leave
receiving module in the factory
position.
Mount the fi xture to a receptacle
and align receiving module per
previous instructions. Insert hole
plug into the screw hole.
NOTE: For temperature protection, the hole plug must be in place prior to using the light fi xture.
Screw in a maximum 75W light bulb into light socket and snap diffuser into light fi xture. Turn receptacle
power back on at fuse box.
Final alignment of the light fi xture to the opener may be needed once the opener is electrically connected.
18
SOCKET
RECEIVING
MODULE
DIFFUSER
ROTATE 90°
(IF NECESSARY)
#6-32 X 3/4”
PHILLIPS PAN
HEAD SCREW
DUPLEX RE-
CEPTACLE
LIGHT
FIXTURE
HOLE PLUG
LIGHT BULB - 75W
MAX. (NOT INCLUDED)
NOTE: RECEPTACLE COVER MUST BE INSTALLED IN BETWEEN THE
LIGHT FIXTURE AND THE WALL
Light Fixture Installation (Continued)