Wayne-Dalton IDRIVE 3982 - Manual (Page 15)

Step 15: Wall Station Installation
15
Locate a convenient place to mount wall station within
sight of the garage door. To keep wall station out of the
reach of children, measure at least fi ve feet up from the
fl oor and secure wall station base into wood wall fram-
ing using (2) phillips head screws. Use 2 of 3 holes
that best align with wood framing. Use anchors (not
included) when fastening to drywall or concrete.
CAUTION: Over tightening screws into wood could
deform plastic base and interfere with circuit board
snaps.
NOTE: Pilot drill mounting holes using a 3/32”
(3mm) bit.
Insert bottom of circuit board behind bottom snap of
wall station base. Pivot circuit board up and snap into
place. For best results, press on circuit board between
battery terminals.
Insert battery onto circuit board being careful to match
(+) positive battery marking with (+) circuit board
marking. Align wall station cover/button assembly
with base. Press cover assembly over base until cover
CIRCUIT
BOARD
BOTTOM
SNAP
PRESS HERE
BATTERY TERMINALS
WALL STATION
REFERENCE LABEL
ENTRAPMENT
LABEL
BASE
COVER
ASSEMBLY
snaps into place. A uniform seam between the cover
and base indicates a proper installation.
Apply wall station reference label and entrapment label
in a convenient location next to the wall station.
(2) PHILLIPS HEAD
SCREWS
Pre-Operation Installation
ALTERNATE SCREW LOCATION