Venturer SHD7000 - Manual (Page 20)

- 19 -
PLAYING A DISC
1. Press the REPEAT button on the remote control.
The repeat modes are listed.
2. Use the / buttons on the remote control to select the repeat mode.
3. Press the OK button on the remote control.
Repeat playback starts.
All Repeat: Repeats the entire disc.
Title Repeat: Repeats the current title.
Chapter Repeat: Repeats the current chapter.
Track Repeat: Repeats the current track.
Disc Repeat: Repeats the entire disc.
A-B Repeat: Repeats the specified segment.
You can specify a segment to repeat. Select this and press the OK button on the remote control.
“
A B Repeat A Point
” appears.
Perform step 1) and 2) below and skip step 3.
1) While the above display appears, press the OK button on the remote control at the start point of the
section you want to repeat.
The display changes to “
A B Repeat B Point
”.
• To cancel the setting, press the REPEAT button.
2) Press the OK button on the remote control at an end point of the section where you want to repeat.
Playback returns to point A and repeats between A and B.
Notes:
• Some discs may not permit repeat playback operation.
• A-B repeat can only be used within the same title. If the start and end of the section to be repeated are
in different titles, A-B repeat is cancelled.
• The A-B repeat function does not operate in scenes where different camera angles are recorded.
• You can cancel repeat playback by pressing the STOP button.
Repeat
All Repeat
Title Repeat
Chapter Repeat
A-B Repeat
Cancel
Note: The selections on the list vary depending on category or status of a disc.
CD DVD
Repeat
Disc Repeat
Track Repeat
A-B Repeat
Cancel
Repeat Playback