Volvo S40 - Manual (Page 175)

2003 Volvo S40 & V40
each track. "SCAN" is displayed as long as the function is activated.
pg. 141 AUM (Advanced User Mode)
AUM (Advanced User Mode)
●
With the radio switched off, press and hold the volume wheel down for at least 5 seconds to start the
AUM function.
●
Turn the 1-20/DISC knob to choose an AUM function (see function list below).
●
When the function has been chosen, the function's default position flashes. Press the 1-20/DISC knob
to choose an alternative (e.g. ON/OFF, LOW/MID/HIGH, etc., depending on the function).
●
Continue to choose function/alternative.
To reset all AUM functions to factory settings, turn the 1-20/DISC knob until "SET TO DEFAULT" is
shown in the display, and then press the same knob. All AUM settings are reset to default position and
the radio reverts to normal status (music, news, etc.).
To save any changes and revert to normal position, turn the 1-20/DISC knob until "BACK and SAVE"
are shown in the display, and press the same knob.
To revert to normal position without saving the changes, turn the 1-20/DISC knob until "BACK
without SAVE" is shown in the display, and press the same knob.
AUM functions (starting position "default" is underscored)
- SET TO DEFAULT (See left-hand column).
- ASC (Active Sound Control) ON/OFF - The ASC function automatically matches the sound volume to
the speed of the car.
- ASC TABLE - Choose level of the ASC function (LOW/MID/HIGH)..
- SRC ON/OFF- Use this function to activate/deactivate the function which reduces the noise in poor
reception conditions. The function is normally used when the radio is in AM mode.
- SRC TABLE - Choose level of SRC function (LOW/MID/HIGH).
- DOLBY NR ON/OFF - Activates/ deactivates Dolby noise reduction when you listen to a cassette tape
(HU 415/615).
- BACK and SAVE (See left-hand column).
- BACK without SAVE (See left-hand column).
pg. 142 Technical data - Audio
HU-415
file:///K|/ownersdocs/2003/2003_SV40/03sv40_10.htm (12 of 13)12/30/2006 4:16:16 PM