Volvo S40 - Manual (Page 116)

2003 Volvo S40 & V40
1. Combined screwdriver/socket wrench
2. Lug wrench
3. Crank (for the jack)
4. Gloves
The screwdriver is combined with the socket wrench. The tools can be alternated by pulling the shaft out
of the handle and re-inserting the opposite end of the shaft into the handle.
Removing the jack
Remove the spare tire out. Loosen the jack slightly by turning the axle (1) and remove it from the
retaining clip.
Replacing the jack
Put the jack in the clip and turn axle (1) until the jack is securely in place.
Replace the tools in the same place.
WARNING!
●
The jack (see the following pages) must be correctly placed in the jack attachment.
●
Be sure the jack is on a firm, level, non-slippery surface.
●
Never allow any part of your body to be extended under a car supported by a jack.
●
Use the jack intended for the car when replacing a wheel. For any other job, use stands to support
the side of the car being worked on.
●
Apply the parking brake and put the gear selector in position P.
●
Block the wheels standing on the ground, use rigid wooden blocks or large stones.
●
The jack should be kept well-greased.
●
Use gloves
file:///K|/ownersdocs/2003/2003_SV40/03sv40_06a.htm (2 of 11)12/30/2006 4:16:11 PM