Viper 671XV - Manual (Page 36)

33 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c .
disarming the vrs ®
Take the time to familiarize yourself with the VRS ® triggering se-
quence and the disarm procedure. It is important to recognize
and identify the VRS ® trigger sequence and know how to disarm
it in case of accidental activation.
Once the VRS ® is armed, it does not disarm automatically. You
must disarm it the next time you operate the vehicle. You must
disarm it with one of the following procedures:
If the system has not entered the triggered sequence (siren has
not started chirping):
1. Turn the ignition on.
2. Press on the 2-way remote for one second.
The lights will flash and the siren will chirp twice.
If the system has entered the triggered sequence (siren has begun
chirping), pressing the disarm button of the 2-way remote will not
disarm VRS ® . To disarm the VRS ® during a VRS ® trigger sequence:
1. Turn the ignition on.
2. Press the Valet ® button the pre-
programmed number of times to
disarm the VRS system.
note: If the VRS ® system has begun its chirping sequence,
the ignition must be turned off, then on to disarm. If you
are driving the vehicle at the time, pull to a safe place
away from traffic and follow the triggered sequence dis-
arm procedure.
DRW-35
➜