Viper 671XV - Manual (Page 11)

8 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c .
Alarm Page
If the alarm system is triggered while armed, an Alarm Page will
be sent to the remote control. When the remote receives an
Alarm Page, the LED icons will display the alarm system status
information and the remote control will generate beeps.
An Alarm Page alert is a series of 10 or 4 rapid beeps and the Red
LED will illuminate. This will repeat every 100 seconds to alert
the user that the alarm system was triggered and will continue
until the alarm page is cleared.
If the shock sensor or optional sensor has triggered the alarm the
remote will display the alarm page with 6 Red LED flashes and
10 rapid beeps.
If the trunk, door, ignition, or hood triggered the alarm the
remote will display the alarm page with the Red LED illumi-
nating for 3-seconds and 4 rapid beeps (repeated 5 times)
Page Recognition (Acknowledgement)
To clear a page alert/notification, quickly press any button on the
remote control. This can be performed at any time during or after
the page notification has occurred.
The remote control will not send a command to the system at
this time; it will only clear future repeats of the page notification.
The next time a button is pressed on the remote control it will
send a command to the system.