Viper 671XV User Manual

Page 18

The remote will indicate disarm notification with 2 beeps and 3

flashes of the Orange LED. If disarming after the system has

been triggered, the remote control will send a diagnostic notifi-

cation as a reminder. These diagnostic notifications are:

1. If a sensor triggered the system, the remote will beep 4-times

and the Orange and Red LEDs flash 3 times.

2. If a switch (Zone 1, 3, 5, or 6) triggered the system, the

remote will beep 4-times, the Orange LED will flash 6-times

and Red LED will illuminate for 3 seconds.

3. If the system was triggered so many times that NPC is active

the remote will emit the above notifications with 5 beeps

instead of 4.

high security disarm

This system includes High Security Disarm feature. If the system

is triggered this feature allows the user to silence the siren and

reset the system to the armed state without having to visually

checking the system status.

After receiving an alarm page:

1. First press any button on the remote to clear the alarm page.

2. Press either the

button again and the High

Security disarm feature will be activated. The siren will be

silenced and the system will reset to the armed state.

3. Pressing the

button once more will fully disarm the

system and allow the vehicle to be accessed.

➜