Vidikron Vision 150 - Manual (Page 15)

Vision Model 140/150 Installation/Operation Manual 1
PRE
L
IMINAR
Y
1.1
About This Manual This Owner’s Manual describes how to install, set up and operate a Vidikron Vision Model 140
or Model 150 LightAmp™ Projector and VHD Controller.
Throughout this manual, the Vidikron Vision Model 140/150 LightAmp™ Projector and VHD
Controller are referred to as the “Vision 140/150.” The information in this manual applies to
both projector models except where otherwise indicated.
Target Audience Vidikron has prepared this manual to help home theater installers and end users get the
most out of the Vision 140/150.
Vidikron has made every effort to ensure that this manual is accurate as of the date it was
printed. However, because of ongoing product improvements and customer feedback, it
may require updating from time to time. You can always find the latest version of this and
other Vidikron product manuals on-line, at www.Vidikron.com.
If You Have Comments About
This Manual... Vidikron welcomes your comments about this manual. Send them to [email protected].
Textual and Graphic
Conventions Text Conventions: The following conventions are used in this manual, in order to clarify the
information and instructions provided:
• Remote and built-in keypad button identifiers are set in upper-case bold type; for
example, “Press EXIT to return to the previous menu.”
• Computer input (commands you type) and output (responses that appear on-screen) is
shown in monospace (fixed-width) type; for example: “To change the aspect ratio to
Letterbox, type LETTERBOX .”
• All keys with functional names are initial-capped, set in bold type and enclosed in angle
brackets. These keys are the following: , , ,
and .
• indicates that you may press either the RETURN or ENTER key on your keyboard
if it has both keys.
In addition to these conventions, underlining, boldface and/or italics are occasionally used to
highlight important information, as in this example:
1
Introduction
A carriage return must be used after each command or string.
Note