Vidikron Vision 150 - Manual (Page 102)

Maintenance and Troubleshooting
88 Vision Model 140/150 Installation/Operation Manual
PRE
L
IMINAR
Y
Power and Cooling
46 Red DMD heat sink overheated.
47 Green DMD heat sink overheated.
48 Blue DMD heat sink overheated.
49 Prism overheated.
4C Projector shutdown due to critical error.
C0 Lamp blower failure (lamp not turned on).
51 LVPS fan failed (Fan 1).
52 LVPS/Red cooling fan failed (Fan 2).
53 DC lamp fan failed (Vision 140; Fan 3).
54 Red DMD heatsink fan failed (Fan 4).
55 Green DMD heatsink fan failed (Fan 5).
56 Blue DMD heatsink fan failed (Fan 6).
57 TIPM fan failed (Fan 7).
58 TIPM fan failed (Fan 8).
Table 5-2. Vision 140/150 Error Codes (continued)
Code Description
Note: To clear a system error, press the EXIT key (on the projector’s rear-panel keypad) twice. If necessary,
reset the projector by powering it off, allowing it to cool and powering it on again. Contact your Vidikron
dealer or Vidikron technical support if the error persists.