VTech t2350 - Manual (Page 7)

www.vtechphones.com GETTING STARTED
G
ett
in
g S
ta
rte
d
Installation
Charge the Handset Battery
Place the handset in the base CHARGING... will display Be sure to charge the battery for at least 16
hours before using your phone
Set Language Mode
• Press PROG, then press or until LANGUAGE is displayed Press SELECT.
• The current setting blinks Press or until the screen displays the correct language
• Press SELECT to save your selection
Check for Dial Tone
After the batteries are charged, pick up the handset and press TALK; you should hear a dial tone If you
do not, try this phone in another phone jack
Set the Dial Mode
If you have touch tone service, the phone is ready to use as soon as the battery is charged If you have
pulse (rotary) service, you’ll need to change the dial mode
• Press PROG.
• Press or until the screen displays DIAL MODE: and the current setting
• Press SELECT. The current setting blinks
• Press or to select TONE or PULSE.
• Press SELECT to save
Set Handset Date and Time
If you subscribe to caller ID service, the date and time will be set automatically with the first incoming
call If you do not have caller ID service, you can set the date and time manually:
• Press
PROG, then press or until DATE/TIME is displayed Press SELECT.
• The month is flashing. Press or until the screen displays the correct month Press SELECT
• The day is flashing. Press or until the screen displays the correct day Press SELECT.
• The hour is flashing. Press or until the screen displays the correct hour Press SELECT.
• If the phone will
not be used for a
long period of time,
remove the battery
to prevent possible
leakage
• If you have any
trouble installing
your phone,
please refer to the
Troubleshooting
section near the
end of this manual