VTech t2350 - Manual (Page 39)

www.vtechphones.com 39
Additional Information
ADDITIONAL INFO
Problem Suggestion
CL is flashing in the
base message display
window
• You need to set the day and time Refer to the section(s) on setting the clock in this
user’s manual
Common cure for
electronic equipment
If the unit does not seem to be responding normally, then try putting the handset in its base If it
does not seem to respond, do the following (in the order listed):
1 Disconnect the power to the base
2 Disconnect the handset battery, and spare battery, if applicable
3 Wait a few minutes
4 Connect power to the base
5 Re-install the battery(ies)
6 Wait for the handset to re-establish its link with the base To be safe, allow up to one minute
for this to take place
Troubleshooting
If you subscribe to DSL service:
If you hear noise during conversations and/or your caller ID
features aren’t functioning properly, install a noise filter to the
telephone line between the base unit and the telephone line
jack. Contact your DSL provider to obtain a noise filter.
To single telephone jack (RJ11C)
Telephone line cord
Noise filter
(For xDSL users)