Visioneer MFC7050C - Manual (Page 55)

I N I T I A L S E T U P
5-3
Initial Setup
Entering Text
When you are setting certain functions, such as the Station ID, you
may need to enter text into the MFC. Most number keys have three
or four letters printed above them. The keys for 0, #, and don’t
have printed letters because they are used for special characters.
By pressing the appropriate number key the correct number of
times, you can access the character you want.
Press Key One Time Two Times Three Times Four Times
2 A B C
3 D E F
4 G H I
5 J K L
6 M N O
7 P Q R S
8 T U V
9 W X Y Z
Inserting spaces
If you want to enter a blank space, press twice.
Making corrections
If you entered a letter incorrectly and want to change it, press
to move the cursor after the last correct letter. Then press
Stop ; all
letters above and to the right of the cursor are deleted. Re-enter
the correct text and/or digits. You can also back up and type over
incorrect letters.
Repeating letters
If you need to enter a character assigned to the same key as the
previous character, press
to move the cursor to the right.