VIEWSONIC VS10945-1G - Manual (Page 12)

ViewSonic N4200w 10
Remote control
The following table describes the functions for the Universal Remote control.
A 信号源 (SOURCE) Select Input Source (e.g. Video, Antenna, PC).
B 0~100+ channel selectors
Use these buttons to select a channel.
C 音量 (VOL+ / VOL-) Adjust Volume.
D
UP/DOWN/LEFT/ RIGHT/ OK
buttons
UP/DOWN for OSD function select and LEFT/
RIGHT for function adjust. Press OK to confirm
your selection.
E 静音 (MUTE)
Temporarily switch off audio output retaining
the current volume settings.
F 暂停 (FREEZE)
Press this button to hold the current display.
Press again to release the picture. Note this is
not the same as pause and the underlying
broadcast continues.
G 显示 (DISPLAY) Display the current input source and time.
H 画中画/画外画 (PIP/POP ) Activate PIP feature (Activate Guide).
I 画中画/信号源 (PIP/SOUR) Press to toggle the Sub picture between PIP.
J 画中画/位置 (PIP/POS)
Change the display position of the Sub Picture
in PIP mode.