Vertex Standard VX-8R - Manual (Page 161)

VX-8R O
PERATING
M
ANUAL
159
S
ET
M
ODE
I
TEM
99: TONE FREQUENCY
Function: Setting of the CTCSS Tone Frequency
Available Values: 50 standard CTCSS tones
Default: 100.0 Hz
S
ET
M
ODE
I
TEM
100: TONE-SRCH MUTE
Function: Enables/Disables the receiver audio output while the Tone Search Scanner is
activated.
Available Values: ON / OFF
Default: ON
S
ET
M
ODE
I
TEM
101: TONE-SRCH SPEED
Function: Selects the Tone Search Scanner speed.
Available Values: FAST (2.5 tone/sec) / SLOW (1.25 tone/sec)
Default: FAST (2.5 tone/sec)
S
ET
M
ODE
I
TEM
102: TOT
Function: Setting of the TOT time
Available Values: OFF / 0.5min - 10.0min (0.5min/step)
Default: 3.0min (3 minutes)
The time-out timer shuts off the transmitter after a continuous transmission which is equal
to the programmed time.
S
ET
M
ODE
I
TEM
103: UNIT OFFSET
Function: Cariblating the Sensor Unit.
Available Values: BARO:
–1 000 ~ +1000, ALTITUDE: –1 000 ~ +1000
Default: BARO: 0, ALTITUDE: 0
S
ET
M
ODE
I
TEM
104: UNIT SELECT
Function: Select the measurement units of the Sensor Unit.
Available Values: TEMP: °C / °F, BARO: hPa / mb / mmHg / inch, ALTITUDE: m / ft
Default: Depends on the transceiver version
S
ET
M
ODE
I
TEM
105: VFO MODE
Function: Selects or disables the VFO band edge limiting for the current band.
Available Values: ALL / BAND
Default: BAND
ALL:
When the VFO frequency reaches the high edge of the current band, the VFO
frequency will jump to the low band edge of the next band (or vice versa).
BAND: When the VFO frequency reaches the high band edge of the current band, the
VFO frequency will jump to the low band edge of the current band (or vice versa).
S
ET
M
ODE
S
ET
M
ODE
S
ELECTION
D
ETAILS