Headlamps, Lighting panel, 02 instruments and controls – Volvo S60 S60R User Manual
Page 50
02 Instruments and controls
49
Lighting panel
02
Headlamps
Automatic dipped beam (certain
countries)
Dipped beam comes on automatically when
the ignition key is turned to position II, ex-
cept when the headlamp control (1) is in the
centre position. If necessary the automatic
dipped beam can be deactivated by an au-
thorised Volvo workshop.
Automatic dipped beam, main beam
– Turn the ignition key to position II.
– Dipped beam is activated by means of
turning the headlamp control (1) clockwise
to the end position.
– Main beam is activated by means of mov-
ing the left-hand stalk switch towards the
steering wheel to the end position and
releasing it, see page 51.
The lamps are switched off automatically
when the ignition key is turned to position I
or 0.
Position/parking lamps
Position/parking lamps can be switched on
irrespective of ignition key position.
– Turn the headlamp control (1) to the centre
position.
When the ignition key is in position II the po-
sition/parking lamps and number plate light-
ing are always on.
Headlamp levelling
The load in the car changes the vertical align-
ment of the headlamp beam, which could
dazzle oncoming motorists. Avoid this by ad-
justing the height of the beam.
– Turn the ignition key to position II.
– Turn the headlamp control (1) to one of the
end positions.
–
Roll the control (3) up or down respective-
ly to raise or lower beam alignment.
Cars with Active Bi-Xenon and Bi-Xenon
headlamps
1
have automatic headlamp level-
ling, so there is no control (3).
Instrument lighting
The instrument lighting is switched on when
the ignition key is in position II and the head-
lamp control (1) is in one of the end positions.
The lighting is automatically dimmed during
the day and can be controlled manually at
night.
– Roll the control up or down (5) for brighter
or dimmer lighting.
Position
Specification
Automatic/deactivated dipped
beam. Only main beam flash.
Position/parking lamps
Automatic dipped beam. Main
beam and main beam flash
work in this position.
1
Option.