Viking F20111B (M0306VR) - Manual (Page 7)

13 12
Single Front or Rear Elements
Push in and turn the control knob counter-
clockwise to the desired setting. The element
will adjust the power output to maintain the
desired heat setting. When finished boiling,
turn the control knob to Med HI to maintain
the boil or to a lower setting for steaming,
warming, and simmering sauces.
Rear and Bridge Element (36”W. Models Only)
Push in and turn the control knob counterclockwise to the desired set-
ting. The element will adjust the power output to maintain the desired
heat setting. When finished, turn all controls OFF.
Remember that induction cooking is instantaneous and boiling time is
decreased when using the proper induction cookware.
Surface Operation Surface Operation
O
p
e
ra
tio
n
O
p
e
ra
ti
o
n
Indicator Light Reason
No display Elements off with cool surface.
Solid The element is ON and sensing the proper cook-
ware.
Flashing 1. Element is OFF - hot surface.
2. Element is ON - cookware is not present or
cookware is not induction cookware. (See
recommended cookware in “Before Using
Cooktop” section.)
Note: If ALL elements are turned to HI for a long period of time, the
internal temperature inside the cooktop may rise, causing the cooktop
to turn off.
CAUTION
Do not heat empty cookware or let cookware boil dry. The cookware can
absorb an excessive amount of heat very quickly, resulting in possible
damage to the cookware and ceramic glass.
Surface Cooking Tips
• The minimum pot or pan diameter recommended is 5” (13 cm).
Use of pots or pans as small as 4” (10 cm) is possible but not recom-
mended.
• Remember to use the proper size cookware for the size element
chosen. Smaller cookware should be used for smaller elements and
larger cookware should be used for larger elements.
• If the induction elelments are left on for more than 60 seconds, with-
out the proper induction cookware, the cooktop will turn OFF.
Note: If flashing continues after making adjustments according to the
flashing descriptions above, refer to the “Troubleshooting” section.
Surface Indicator Lights
The surface indicator lights are located at the front of the glass cook-
top. The indicator lights are used to indicate activation, hot surface,
and warnings.
HOT
REAR
FRONT
HOT
REAR
FRONT